In fact! Our technical experts are providing the complete research support for the research scholars based on the implementation of underwater sensor network simulation using network simulator 3 through this article.
Step: 1 Download Aqua-Sim Module
Firstly, we have to download the aqua sim module to perform the underwater sensor network simulation through the utilization of network simulator 3 over the below mentioned URL.
![Link to Download Aqua Sim Module](https://ns3simulation.com/wp-content/uploads/2023/01/download-Aqua-Sim-module-1024x601.png)
Step: 2 Load Aqua Sim into Ns-3.26
Then, we have to copy the aqua sim which is downloaded already and paste that in the below mentioned location and shown in the image.
/home/research/ns-allinone-3.26/ns-3.26/src
![](https://ns3simulation.com/wp-content/uploads/2023/01/Load-Aqua-Sim-into-ns-3.26-1024x576.png)
Step: 3 Configure Aqua Sim for Underwater Sensor Network Simulation
At that time, we have to configure the aqua sim through the execution of the below mentioned commands.
cd /home/research/ns-allinone-3.26/ns-3.26
sudo ./waf configure
![](https://ns3simulation.com/wp-content/uploads/2023/01/Configure-Aqua-Sim-for-Underwater-Sensor-Network-Simulation.png)
Step: 4 Install Ns-3.26 with Aqua-Sim
Finally, we have to install the packages based on ns-3.26 along with the aqua sim for the underwater sensor network simulation through the execution of the highlighted commands.
cd /home/research/ns-allinone-3.26/ns-3.26
sudo ./waf build
![Installation of Ns-3.26 with Aqua Sim](https://ns3simulation.com/wp-content/uploads/2023/01/Install-ns-3.26-with-Aqua-Sim-.png)
Now, you guys can just begin to implement by your own and hit us through various platforms if assistance required.